New computer computer, getting, figure

Newbie

Built it but it's not getting power at all tryin to figure it out

kakakuku

1.did u turn on the switch on the power unit ( not on the computer)?
2. did you connect your power unit to your motherboard i beive normally its a 24pin+big pipe+some 2-4pins small line

Yuma

SOME DISPLAY CARD NEＥＤ TO USE MOTHERBOARD TO　ＧＥＴ　ＭＯＲＥ　ＰＯＷＥＲ　ＳＵＰＰＯＲＴ，ＢＯＴ　ＪＵＳＴ　ＣＯＮＮＮＥＣＴ　ＴＨＥ　ＡＣ　。。。。Ｕ　ＣＡＮ　ＥＡＳＹ　ＣＨＥＣＫ　ＴＨＥ　ＤＩＳＰＬＡＹ　ＣＡＲＤ＂Ｓ　ＦＡＮ　ＩＳ　ＲＵＮＮＩＮＧ　ＯＲ　ＮＯＴ　ＴＯ　ＭＡＫＥ　ＳＵＲＥ　ＴＨＥ　ＰＯＷＥＲ　ＩＳ　ＥＮＯＵＧＨ。。。

Newbie

Now power and everything is working. My problem now is I'm using old HDD from my last computer. It boots up like its going to load then gives me 2 options boot windows normally. Or run automatic repair ( recommended )

If I push load windows properly I get a message saying new hardware not recognized. But I can't add drivers if it's not letting me log in.

Then the next part recommended fix only suggest to load computer to an earlier date, when everything was running ok.

Yuma

sonetimes u can not load Window if u change many hardware ..
in that time,u can try to reinstall window (try to install win in other drive )
then u can load window...

Newbie

Today I'm just going to take it to the repair shop and let them mess with it. Now my patience are running thin lol